Patch, Replace, and Protect

Honest Concrete Repair Services in Delano, MN

Cracked steps, pitted garage floors, and scaling walkways do not fix themselves. Our crews patch what still has life, replace what does not, and seal the result so Minnesota winters have less to work with.

Patch or Replace, We Tell You Straight

Concrete repair fixes cracked, pitted, or crumbling slabs. We patch surface damage and replace sections that have heaved, sunk, or broken apart. The right fix depends on how deep the damage runs, so we check it in person first.

Most homeowners wait too long. A crack that was a hairline in October is a quarter inch wide by March. The step that wobbled last spring is crumbling at the edges now. Repair is cheapest when it happens early.

Drews Industries is a concrete company first. Our ACI-certified foremen lead crews that pour, finish, coat, and seal slabs across the Twin Cities.

  • Surface patching for cracks, pits, and chips
  • Full replacement for heaved or broken slabs
  • Coatings and sealers that protect the repair
  • Free on-site concrete estimate with an honest read
Get a Free Estimate 

Send us a quick note about the damage and where it is. We will tell you if it needs a patch or a new pour.

This field is for validation purposes and should be left unchanged.
Address(Required)
Bare concrete garage slab before a floor coating

Reading Concrete Damage Before Picking a Fix

Our first step is a walk around the damaged concrete with you. We note crack width, pitting, trapped moisture, and any sealer or paint that will need removal.

A few warning signs point to deeper trouble in the slab.

  • Cracks that keep growing each spring
  • Concrete edges that crumble when you sweep them
  • Steps that rock underfoot
  • Puddles that sit in the same low spot on the slab

Rust stains bleeding through a crack can mean water has reached the steel inside. Surface damage usually patches well. Slabs that have heaved, sunk, or broken into loose pieces rarely hold a patch for long.

Concrete Crack Repair Inside Our Coating Process

Many of our repairs happen as part of a floor coating project. Garage and basement slabs collect cracks and pits over the years, and a coating only looks as good as the surface under it.

Before any color goes down, our crew grinds the slab. Grinding opens the pores and exposes weak spots. HEPA vacuums pull the dust, then we fill each defect with patch material matched to the job.

That is concrete crack repair with a purpose. The patches sit sealed under a layered coating instead of facing salt and water alone. For homeowners, that work carries our lifetime warranty while you own the home.

Flatwork

Replacing Concrete That Cannot Be Saved

When a slab is too far gone, we remove it and pour new concrete. Our flatwork crews handle driveways, patios, walkways, stoops, and steps.

New pours use a 4500 PSI mix with 6 percent air on most projects, based on mix designs from Cemstone engineers. That air helps concrete survive freeze and thaw. We compact the base, set rebar, and finish most pours in a single day.

Vibratory plate compactor used for construction and paving work at Drews Industries site.
ACI-Certified Foremen
Repair Path

How We Decide Between Repair and Replacement

Not every crack needs new concrete, and not every patch will last. These steps show how we pick the right fix. We explain each finding in plain words.

1. Find the Cause Behind the Crack

Cracks come from frost, poor drainage, or a weak base. We look for the cause first. A patch over an active problem fails again by the next thaw.

2. Measure Movement and Height Change

Sections that have sunk or lifted need more than a patch. We check how far each section has moved, and if it is still moving, before we suggest any fix for your slab. Movement changes everything. Big drops point to base problems. Those need more than filler, and a patch on top would only hide the movement for a season.

3. Repair or Pour New Concrete

Stable cracks get filled. Sections that have failed get torn out and poured new by our flatwork crew, with a compacted base underneath so the new slab stays level for years. You get one crew and one schedule.

4. Protect the Repair

A sealer or coating protects the fixed area from salt and water. That step keeps the repair from turning into a new problem next spring. It also gives the surface an even look.

Keeping Repaired Concrete in Good Shape

A repair is only half the job. The other half is slowing down what caused the damage. Our Clean and Seal service treats stains, scrubs and dries the surface, then applies an acrylic or penetrating sealer. Plan to reseal most outdoor concrete every two to three years.

Coating a Repaired Slab Indoors

Indoors, a full coating system does the protecting. Garages and basements trade outdoor weather for road salt, tracked water, and spills. A coating turns a patched slab into a sealed, easy-care floor.

Many owners pair floor repairs with epoxy flooring or other concrete coatings so the fixed surface stays protected. Our coating styles page shows chip, metallic, solid color, and quartz options.

Why Drews Industries

Why Homeowners Call Drews for Concrete Repair

Some companies only patch, and others only replace. We do both, so our advice is not tied to one service. That lets us give you a fair answer. Every time.

Repairs Matched to the Real Problem

Our recommendation comes from what your concrete needs, not from the one service a company happens to sell. You get the fix that lasts longest.

Repairs That Can Be Coated to Match

After repair, we can coat the slab so patches do not show. Your garage or patio looks like one finished surface again. Most owners never see the old cracks again.

Tidy Repair Sites and Steady Updates

Reviewers mention our on time crews and tidy job sites. We protect nearby walls, clean up, and walk the finished repair with you. You never come home to a mess.

What People Ask Before a Concrete Repair

Can every crack in concrete be patched?

No, only surface damage patches well. We can fill and seal hairline cracks, chipped edges, and salt pitting. Slabs that have heaved, settled, or broken into loose pieces keep moving, so a patch would crack again within a season or two. Those sections need replacement to give you a lasting result.

Do you repair concrete before coating a garage floor?

Yes, crack and pit repair is a standard part of our coating prep. We grind the slab first, which exposes weak spots, then fill every crack and pit before the base coat. The coating layers seal the patches in. That is why most garage floors look smooth and even when we finish.

Can you replace just one section of a driveway or walkway?

In many cases, yes. We can cut out a damaged section and pour new concrete in its place. During the estimate, we look at how the new pour will meet the old slab, including height, color, and joints. We explain the options and the likely look before you decide.

How do I keep repaired concrete from failing again?

Seal outdoor concrete every two to three years, keep water draining away from slabs, and clear heavy salt buildup during winter. Fix new cracks while they are small. Indoors, a full coating protects garage and basement repairs from salt and spills. Each habit cuts the water and frost that caused the damage.

How long does new concrete need before sealing or coating?

New concrete needs about 30 days to cure before we seal or coat it. Sealing too early can trap moisture and cause the finish to fail. If we pour in late summer, there is usually time to seal before the first salt of the season, which gives the slab the best start.

Get a Free Estimate

This field is for validation purposes and should be left unchanged.
Address(Required)
Free Estimates

Fix the Concrete Before Another Winter Hits

Small concrete problems turn into big ones fast in Minnesota. We will look at your slab, steps, or walkway and explain which fix makes sense. Then you get a clear plan for concrete repair in Delano and across the metro. Call (763) 972-4010, or see our residential concrete coatings.