Garage Floors in Delano and the West Metro

Winter-Tough Garage Floor Coatings in Delano, MN

Your garage is the room that meets winter first. We grind the slab, patch the damage, and lay a three-layer coating that keeps salt brine on top, where a squeegee and hose can clear it away.

A Sealed Garage Slab Stops the Salt Damage

Garage floor coatings protect your slab by sealing it under a primer, a chip base, and a clear topcoat, so salty meltwater can no longer soak in and freeze. That stops the pitting and flaking that ruin most Minnesota garage floors.

Picture the daily routine. You pull in from a commute on Highway 12, and a frozen clump of road grime drops off the wheel well. The engine warms the garage, the clump melts, and salty water creeps toward the drain. Repeat that from November to April. By spring, pits dot the concrete near the door.

Drews Industries coats garages across Delano and the West Metro from our shop on Johnson Drive.

  • Polyurea primer, chip base, and UV-stable polyaspartic topcoat
  • Walk on the floor in about 24 hours
  • Lifetime coating warranty while you own the home
  • Optional 8 by 20 foot storage unit for a packed garage
Get a Free Estimate 

Tell us how many stalls you have and what bugs you about the floor. We will bring chip samples to the visit.

This field is for validation purposes and should be left unchanged.
Address(Required)
Bare concrete garage slab before a floor coating

Salt and Frost Wear Down a Bare Garage Slab

Outdoor concrete freezes and thaws a few dozen times each winter, but a heated or sunny garage slab can go through that cycle almost every single day. Ice melts under a warm engine, water seeps into the pores, and the slab refreezes once the door shuts for the night.

Road salt makes the garage floor problem worse in three ways.

  • It keeps the garage slab wet for longer.
  • It carries chloride deep into the concrete surface.
  • It lets meltwater stay liquid at lower temperatures, so the slab sees more wet and frozen swings each week.

Over a few seasons, the top layer turns soft and sandy and starts to scale. A coated slab gives that water nowhere to go. Fixing a scaled floor later costs far more than sealing a sound one now.

Garage Concrete Coatings That Bond Instead of Peel

Store-bought kits fail for one reason. They go onto smooth, dirty concrete that nobody opened up first. Garage concrete coatings only last when the slab can grab them.

Our crew grinds the whole floor with professional equipment. The grinder strips weak surface paste, old sealer, and tire marks. It also roughens the surface so the primer has something to bite. HEPA vacuums pull the dust as we go, and we fill every crack and pit before any coating touches the floor.

Three Layers

Inside Our Epoxy Garage Flooring System

Most people search for an epoxy garage floor when they start shopping. Good instinct. Our epoxy garage flooring upgrade builds on that idea with three layers made for a Minnesota garage that sees salt, slush, and subzero mornings all winter. A polyurea primer locks onto the ground slab, and a base coat holds the decorative chips in place. Then a polyaspartic topcoat seals everything in under a clear, tough layer.

Plain epoxy flooring is tough indoors, but it can yellow in direct sun. Summer weekends leave the door open for hours, and the strip near the opening gets real light. Our UV-stable topcoat keeps that strip the same color as the rest of the floor.

White garage with a gray chip floor coating
Lifetime Warranty
Your Garage Week

What a Garage Coating Week Feels Like at Home

Losing the garage for a few days is the only real hassle. Here is how the days usually unfold, so you can plan where the cars and kids will go.

1. Empty the Garage the Night Before

Clear shelves on the floor, bikes, and anything you want safe from dust. Wall shelving can stay, since our crew wraps walls and shelving units in plastic before grinding starts.

2. Grinding Day Gets Loud for a Few Hours

Our grinders run with HEPA vacuums attached, so very little dust escapes. The crew fills cracks and pits right after, while the garage door stays open for fresh air.

3. Chips Fly and the Floor Changes

The base coat goes down and our crew throws chips by hand until the gray concrete disappears. Kids love watching this part from the driveway.

4. Topcoat, Then a Short Wait

After the topcoat, light foot traffic can come back in about 24 hours. Cars wait a few more days, and your crew lead gives you the exact date to park inside.

Chip Blends That Hide a Busy Garage

Decorative chips are the top pick for garage floors. The texture grips wet boots, and the speckled pattern hides salt film and sand between cleanings. Darker blends like Steelcut keep a working garage looking clean. Warmer options like Brickyard and Stonycreek pair well with tan or brown siding.

Why Drews Industries

Why Delano Families Trust Drews With Their Garage

Your garage takes the worst of Minnesota winter, from salt brine to frozen slush. Our system and our warranty are both built around that reality.

Coverage for as Long as You Own the Home

Your garage coating stays under our lifetime warranty while the house is yours. A failure tied to our install or our materials gets fixed by our crew at no cost to you.

Chips Laid Thick Enough to Hide Salt Marks

We broadcast chips to full coverage, never a light sprinkle. That dense layer hides dried salt rings and tire marks between washes, which matters from November to April.

Reviews That Mention Clean Garages

Our 5.0 Google rating comes from homeowners who noticed swept floors, wrapped shelving, and on time crews. That care is part of the job, not an extra charge.

Garage Floor Answers Before You Book

Does snowmelt make a coated garage floor slick?

A chip floor stays grippy when wet, because the chips leave a light texture in the topcoat. That grip helps when snowmelt runs off a car and pools near the door. For extra traction near steps or the house entry, we can add fine grit to the topcoat in those spots without changing the look.

The last owner painted this garage floor. Is that a problem?

Old paint is not a problem once we grind it off. Paint sits on the surface and peels, so new layers cannot bond over it. Our grinders take the slab down to clean, open concrete, removing loose paint, sealer, and tire marks. We check for old coatings during the estimate, so the price already covers removal.

My garage slab has a long crack. Can it still be coated?

Yes, we can coat most cracked garage slabs after repair. We fill cracks and pits during prep, then the coating layers cover the patch. If the slab has heaved, sunk, or broken into loose pieces, we will say so. Our flatwork crew can pour a new slab, then coat it once the concrete cures.

How long does a garage floor coating take to install?

Most garage floors take one or two days of work on site. Day one covers grinding, patching, and the base layers, and the topcoat follows once the base cures. You can walk on the floor about 24 hours after we finish. Vehicles wait a few days, and your crew lead gives you the exact date.

How do I clean a coated garage floor in winter?

Push slush out with a floor squeegee after storms, then rinse salt film every few weeks so it does not dry white. A soft broom handles sand the rest of the time. The sealed topcoat keeps brine on the surface, so you never scrub grime out of open pores. Your crew leaves written care tips at the walkthrough.

Get a Free Estimate

This field is for validation purposes and should be left unchanged.
Address(Required)
Free Estimates

Pull Into a Better Garage Next Winter

Your garage should not crumble one salty puddle at a time. We will check the slab, explain each option, and give you a written price for garage floor coatings made for this climate. Ring (763) 972-4010 or use the form, and we will find a time. See all of our home options on the residential concrete coatings page.