Delano, MN and the West Metro

Lasting Residential Concrete Coatings Made for Delano, MN

Salt, frost, and spring melt wear bare concrete down fast. Drews Industries grinds, patches, and coats the slabs around your home, then backs the floor for as long as you own the house.

Home Concrete Coatings Sealed Against Winter

Residential concrete coatings seal the slabs around your home under a hard, layered finish. Water and road salt then sit on top instead of soaking in. That one change stops most of the flaking, dusting, and staining that Minnesota slabs suffer.

One winter can do more harm to bare concrete than a whole summer of use. Water sinks into the pores, freezes overnight, and pushes the surface apart from the inside as the ice grows. Salt keeps that cycle going.

Drews Industries works out of 710 Johnson Drive in Delano, and our ACI-certified foremen lead every crew that leaves the shop. We pour concrete as well as coat it. We know what sits under a coating because we place that concrete too.

  • Three-layer coating system with a UV-stable polyaspartic topcoat
  • Light foot traffic on the new floor in about 24 hours
  • Lifetime coating warranty for as long as you own the home
  • Free on-site concrete estimate anywhere in the Twin Cities metro
Get a Free Estimate 

Tell us which slab bugs you most. A Drews estimator will check it in person and send a clear, written price.

This field is for validation purposes and should be left unchanged.
Address(Required)
Garage floor coating with bikes on the wall and the door open

Coatings for Every Slab Around Your House

Most homes have more bare concrete than people think. Each slab wears down in its own way, so we match the coating system to the space and to the way your family uses it every week.

Not sure where to start? Most families coat the garage first, since it takes the most salt and slush of any slab at the house. The rest can follow later.

What Goes Into Our Residential Epoxy Flooring

Many homeowners start by searching for epoxy flooring for homes. That is a fair place to begin, since epoxy is the word most people know for a hard, glossy coated floor. Our home system builds on the same idea with three layers, and each layer has one job.

  1. A polyurea primer soaks into the freshly ground slab and grips it.
  2. A base coat adds color and holds hand-broadcast chips if you want them.
  3. A clear polyaspartic topcoat seals the floor against salt, spills, and sun.

That top layer flexes as temperatures swing. A garage can sit below zero at dawn and feel mild by the middle of the afternoon on the same January day. Brittle finishes crack, peel at the edges, and let salt water creep back under the coating within a winter or two. Ours moves with the concrete and keeps its color.

Our Guarantee

A Coating Warranty That Lasts While You Own the Home

Every residential coating we install carries a lifetime warranty for as long as you own the house. If the floor fails because of our labor or the materials we chose, our crew comes back and makes it right at no cost to you.

The terms have no fine print. Prep is why that promise holds. A coating rolled over a dirty, smooth slab will lift. A coating bonded to clean, open concrete stays put.

White door on gray speckled floor
Lifetime Warranty
One Visit, Every Slab

How We Plan Coatings Across Your Whole Property

Most homes have more than one tired slab. A single estimate visit lets us plan the garage, basement, patio, and walks as one project instead of four separate calls.

1. List Every Slab on the Lot

Our estimator walks the garage, lower level, patio, steps, and pool deck with you. Each surface gets its own notes on cracks, moisture, and wear, plus a line on the written estimate.

2. Sort Repair From Coating

Some slabs are ready to coat, and some are past saving. Concrete that has heaved or crumbled goes to our flatwork crew for a new pour first, so the coating never sits on a failing base.

3. Match the Product to Indoor or Outdoor

Garages and basements get the system that suits shade and cold. Patios and pool decks get UV chips and a polyaspartic topcoat that hold color in full summer sun.

4. Book the Slabs in a Smart Order

Indoor rooms can go any month. Outdoor slabs wait for a dry, warm stretch. We line up the dates so you never lose the garage and the patio in the same week.

Floor Finishes You Will Still Like for Years

Decorative chip is our most popular home finish by far. The texture gives your feet grip on a wet floor and hides dust, sand, and salt film between cleanings. Blends run from cool grays like Frostbite and Summit to warm mixes like Saddle Tan and Woodland. Metallic suits a basement bar or a home theater with dim, warm lighting. Solid colors give a garage a clean, even look.

Why Drews Industries

Why West Metro Homeowners Pick Drews for Their Slabs

A coating only lasts as long as the concrete holding it. Our crews judge the slab first and the finish second, which is why so many of our floors still look new years later.

Foremen Trained in Concrete

Every job runs under a foreman with American Concrete Institute certification. That training shows in how they spot weak spots, moisture, and failed patches before any primer touches the floor.

New Concrete When Coating Is the Wrong Fix

Some slabs are too broken to coat. Our flatwork crews can tear out and pour a new garage slab, patio, or walk, then we coat it once the concrete cures for about 30 days.

A Home Warranty Without Fine Print Games

Residential coatings carry a lifetime warranty for as long as you own the house. If our materials or our install cause a failure, we come back and fix it at no charge.

Residential Coating Questions We Hear Most

How soon can we walk on a new garage or basement coating?

Most families can walk on the new floor about 24 hours after we finish. Vehicles and heavy furniture wait a few more days, because the layers keep hardening after they feel dry. Your crew lead gives you exact dates for your slab and the weather that week, then leaves written care tips before driving away.

Do we need to empty the garage or basement first?

Yes, the slab needs to be clear before grinding starts, and moving your things is the one big job we hand you. Short on space? We can set an 8 by 20 foot lockable storage unit in the driveway for an added fee. You keep access to it during the project, and it leaves once the floor cures.

Is a coating better than sealing bare concrete?

A coating protects more, while a sealer costs less. A sealer soaks into the slab and blocks some water and salt, but it needs reapplying every two to three years. A coating builds a thick finished surface with color, texture, and stronger protection. We offer both, and our Clean and Seal service suits slabs that only need light protection.

Can Drews Industries pour new concrete before coating it?

Yes. We are a concrete company first, so our flatwork crews pour driveways, patios, steps, and garage slabs. Most pours use a 4500 PSI mix with 6 percent air, built for freeze and thaw cycles. New concrete cures for about 30 days before a coating goes on, and we schedule both jobs for you.

What does the lifetime warranty on home coatings cover?

The warranty covers coating failures caused by our workmanship or our materials for as long as you own the home. That includes peeling or lifting tied to how we prepped and installed the floor. It does not cover damage from outside causes like a heaving slab. We explain every term during your estimate, in plain language.

Get a Free Estimate

This field is for validation purposes and should be left unchanged.
Address(Required)
Free Estimates

Let Us Walk Your Concrete With You

Pick the slab that bothers you most, or have us look at all of them in one visit. Our team will check the concrete and explain your choices. Then you get a written price for residential concrete coatings. Call (763) 972-4010 or use the form, and we will set a time that works for you. You can also learn more about our team on the Drews Industries home page.