Driveways in Delano and the Twin Cities

Salt-Proof Driveway Coatings for Delano, MN Homes

Plows, salt trucks, and January thaws are hard on a driveway. We check the slab first, then recommend the right protection, from a UV-rated chip coating to a clean and seal that keeps brine out.

The Right Driveway Protection Depends on the Slab

Driveway coatings protect concrete from road salt, water, and freeze damage by sealing the surface. You can choose a full UV-stable chip system or a penetrating or acrylic sealer. Which one fits depends on the age and condition of your slab, so we check it in person first.

A driveway is the one slab nobody gets a break from. You drive on it daily, shovel it after every storm, and track brine across it from November to April. Along Highway 12 and the county roads around Delano, the salt trucks never stop.

We pour driveways as well as protect them, so we look at your slab the way a concrete crew does.

  • Full UV chip coating for color and texture
  • Clean and Seal for sound slabs on a budget
  • New 4500 PSI pours when the slab is too far gone
  • Honest advice on which driveway option fits
Get a Free Estimate 

Tell us how old your driveway is and what you see on it. We will tell you if it needs a coating, a seal, or a new pour.

This field is for validation purposes and should be left unchanged.
Address(Required)
Heavy concrete pouring at residential construction site by Drews Industries.

What Minnesota Winters Do to a Driveway

Concrete soaks up water. Lots of it. In a Wright County winter, that water freezes deep in the slab, swells, and pushes the surface apart from inside. Deicing salt speeds the cycle and keeps the surface wet long after the snow is gone.

The first signs of driveway damage are small.

  • A rough concrete patch near the garage apron
  • A few pits in the slab where the plow scraped
  • A hairline crack in the driveway that holds water after every melt

Then the top layer starts to scale in thin flakes. Left alone, scaling spreads, and the repair bill grows with it. Sealed concrete coatings stop the cycle at the surface.

A Full Outdoor Chip Coating for the Driveway

For homeowners who want color and texture, our decorative chip system can go outside. We make the UV Collection chips for sun, with blends named after house styles like Farmhouse, Craftsman, and Chalet. The chips sit in a base coat under a polyaspartic topcoat that holds its color.

Some homeowners start by searching for an epoxy driveway online. Standard epoxy is an indoor material that yellows in sunlight, so our outdoor systems use UV-stable layers instead. It is the same reason our indoor epoxy flooring stays indoors.

Chip systems also leave a slight texture that gives boots more grip in slush. Ice still needs clearing and treating, as it does on any Minnesota surface.

Clean and Seal

A Professional Seal for Sound Driveways

Many driveways do not need a full coating. A professional clean and seal brings back the color of the concrete and blocks moisture, oil, and salt. We power wash, treat stains, let the slab dry, and apply an acrylic or penetrating sealer picked for your concrete.

Plan to renew a concrete driveway sealer every two to three years. Traffic and sun exposure decide where in that range your driveway falls. Learn more on our Clean and Seal page.

Industrial concrete sealant and epoxy tools from Drews Industries for construction and masonry projects.
ACI-Certified Foremen
New Concrete

When a New Driveway Makes More Sense

Coatings and sealers protect sound concrete, but they cannot rebuild a slab that has heaved, settled, or broken apart. When we see that kind of damage during an estimate, we tell you plainly.

1. Remove the Old Slab

Our flatwork crew breaks out and hauls away the failed driveway. We check the base below for soft spots and drainage issues.

2. Compact the Base Under the Slab

We compact the subgrade and set rebar before the pour. A firm base is what keeps a new driveway from settling.

3. Pour and Finish the Concrete

Our crew pours and finishes most driveways in a single day. We use a 4500 PSI mix with 6 percent air, based on mix designs from Cemstone engineers.

4. Cure, Then Seal or Coat

Fresh concrete keeps curing and gaining strength over about 30 days. After that, we can seal or coat it so it is ready for its first winter.

Matching the Driveway Finish to Your Home

Guests judge a house from the street. Stains pull the eye. A UV chip blend can echo your trim or stone. A sealed natural finish keeps a classic look and deepens the gray. We lay samples on the slab next to your siding during the estimate.

Why Drews Industries

Why Homeowners Trust Drews With Their Driveways

Driveway protection only works when the advice behind it is honest. Many driveways need a simple seal, and some need new concrete. We tell you which one yours needs.

A Seal When a Seal Is Enough

A sound driveway with light wear usually needs a penetrating seal, not a full coating. We recommend the lower cost option when it fits, because clear advice is one of our core values.

Drainage and Edges Checked First

Water that pools at the garage apron or runs under the slab edge ruins any finish. We check slope, edges, and joints before naming a product for your driveway.

Driveway Pours Done In House

When a driveway has sunk or crumbled, our flatwork crew can tear it out and pour new concrete. You deal with one company from demolition to the final seal.

Driveway Protection Answers

Can you coat or seal an asphalt driveway?

No, every coating and sealer we use works on concrete only. Asphalt is a different material that needs its own sealcoat from a paving company. If your home has a concrete apron or walkway next to an asphalt drive, we can still protect those concrete sections with a coating or a seal.

How do I know if my driveway needs a coating or just a seal?

The condition of the concrete and the look you want decide it. Sound slabs with light wear do well with a clean and seal. Owners who want color, texture, and a heavier barrier against salt choose a full chip coating. We check your slab during a free on-site estimate and explain both paths with prices.

How long before I can drive on a coated driveway?

You can walk on a coated driveway the next day in most cases. Vehicles stay off for a few more days while the layers harden all the way through. Your crew lead confirms the exact date based on your slab and the weather that week, so plan to park on the street briefly.

Will a driveway coating hold up to a snowplow?

A coated driveway handles normal shoveling and snow removal, but plow blades and metal shovel edges are hard on any surface. A shovel with a poly edge helps the finish last. If a plow service clears your drive, ask them to raise the blade a bit above the slab or switch to a rubber blade edge.

How soon can a new driveway be sealed or coated?

New concrete needs about 30 days to cure before we seal or coat it. Sealing too early can trap moisture and cause the finish to fail. If we pour your new driveway in late summer, we can seal it before the first salt of the season, which gives it the best start.

Get a Free Estimate

This field is for validation purposes and should be left unchanged.
Address(Required)
Free Estimates

Plan Your Driveway Before the Next Freeze

The best time to protect a driveway is before the next round of salt hits it. We will walk the slab with you, explain which option fits, and give you a written estimate for driveway coatings in Delano and across the Twin Cities metro. Call (763) 972-4010, or see our other residential concrete coatings.